shape factor
英 [ʃeɪp ˈfæktə(r)]
美 [ʃeɪp ˈfæktər]
形状系数；波形因数
双语例句
- Static Characteristics for Metal-Rubber Structure with Different Shape Factor
形状因子变化时金属橡胶结构的静态力学性能分析 - According to the development of the future wind-induced response, this paper introduces and summarizes the way of calculating on dynamic coefficient and shape factor.
针对目前膜结构的风振响应分析发展状况，本文对膜结构的风振系数和体形系数的确定做了初步探究和总结。 - And a shape factor is introduced into the expression, which simplifies the theoretical expression.
引入了横截面形状修正因子，简化了公式的表达和计算。 - For any section, the ratio Mp/ My is called the shape factor.
对于任意的截面，比值Mp／My叫做形状系数。 - Discussion on Shape Factor K and Factor K_1 of the Standard Elliptical Head
对标准椭圆形封头形状系数K和系数K1的讨论 - The results show that: With the increasing of the pore size, coordination number and shape factor, the residual oil after polymer flooding decrease;
结果表明：随着孔隙半径、配位数、形状因子的增大，聚驱后剩余油百分含量降低； - The cross sections of various gas channels were equivalent to circles and the shape factor sf was taken to measure their departure from a circle.
将各种不同气道截面等效于圆形，引入形状因子来衡量它们偏离圆形的程度。 - Then theoretical resonance length, small end diameter, displacement node, magnification factor, shape factor and other parameters of the amplitude amplifier pole could be determined.
确定出其理论共振长度、小端直径、位移节点、放大系数、形状因数等参数。 - The homogeneity of column was analyzed quantitatively with the electrical resistivity, the formation factor, the shape factor and the anisotropy factor of core samples along the column.
通过对其电阻率及其表征水泥土微观结构的结构因子、形状因子和各向异性指数的定量分析，阐述了水泥土搅拌桩在水平方向和沿桩身方向的均匀性； - Heat Loss of Wood Drying Kiln Wall Calculated by the Shape Factor Method
利用形状因子法计算木材干燥窑壳体的散热损失 - The influence of the characteristic parameters of the semi-solid alloy melt original structure on the mold filling ability was studied through experimental method; The influence of solid phase fraction, grain size and shape factor of original structure phase on the mold filling ability was analyzed;
采用实验的方法研究了半固态合金熔体原始组织特征参数对充型能力的影响，分析了原始组织初生固相率、晶粒尺寸和形状因子对充型能力的影响。 - The author proposes a joint-optimized algorithm based on Cauchy error estimator, shape factor is adopted in Sigmoid function.
再次，重点提出了用Cauchy函数作为目标函数，同时在转移函数中引入陡度因子，对转移函数的导数进行提升，并在修正权值时各层采用不同尺度的联合优化算法。 - The effects of fuel pellet shape factor, cladding materials and the inside temperature of clad wall on ETC were also discussed.
文中讨论了芯块的形状因子、包壳材料和包壳内壁温度对有效热导率的影响。 - A method and parameter& Shape Factor, which are fit for drawing and recognizing particle appearance with microscope, is proposed.
笔者提出一个适用于显微镜进行颗粒形貌特征提取与识别的方法和指标&形状指数。 - Two parameters, block spectrum intensity Seq and spectrum shape factor a, which describe the characteristics of the loading block spectrum are defined, and the relationship between the parameters and fatigue crack propagation behaviours is investigated.
定义了疲劳载荷谱的两个特征参数：块谱强度和形状因子，由此去描述载荷谱的特征，并研究了特征参数和疲劳裂纹扩展之间的关系。 - Based on the regression of the relationship between the vent hole and the pressure drop, the shape factor of vent hole "S" has been put forward the first time. The effects of "S" on strawberry precooling rate have also been discussed.
在对孔形与压降关系进行回归分析的基础上，首次定义了开孔形状因子S，并讨论了其对草莓预冷速度的影响。 - The effects of packing structure, azimuth factor, shape factor, orientating factor, axis ratio and size uniformity on the packing fraction have been also evaluated.
讨论了堆积结构、方位因子、形状因子、取向因子、轴比和粒度均匀性对堆积系数的影响。 - It has been shown in this paper, that in solving radiation heat transfer problems for finite element model of mechanical construction it is necessary to compute the shape factor matrix.
本文说明了在用有限元模式对机械结构的幅射换热问题进行求解时，必须计算形状因子矩阵。 - Effects of triangle shape factor on precision of crustal deformation calculated
三角形形状因子对地壳形变计算精度的影响 - A new version of shape factor corresponding states principle ( CSP) was presented.
本文提出了一个具有保形溶液理论特点，且参考流体可以选择的新的形状因子对应态原理。 - Correlations between strengths and micropore shape factor have been found.
孔形状因子与水泥石强度之间存在着较显著的相关性。 - To determine the shape factor of wind load and dynamic wind effect factor of this flexible structure, wind tunnel tests with rigid model and elastic model were done, and the contents and results are summarized.
为了确定该柔性结构的体型系数和风振系数，进行了刚性模型和弹性模型的风洞试验，对试验内容和成果进行了总结介绍。 - The response time of sensors by various shapes of the gel is also compared, it proved the influence of the shape factor to the ion osmosis and stress balance in the gel.
用不同形状的凝胶制作探头，比较其响应时间，证实了形状体积因素对离子渗透和应力平衡的影响。 - Morphology and size of the microstructure in semi-solid forming were quantitatively examined by shape factor and equivalent diameter of primary α phase and the measured data were listed.
用初生α相的形状系数和等效直径定量描述半固态组织的形貌和尺寸，给出了测定数据。 - So it can replace data from the teeth shape factor curve and theoretical stress concentration factor curve.
可以替代依靠查齿形系数，应力修正系数线图获得数据的传统方法。 - The analysis results have shown that the average shape factor of eutectic silicon phase provides a correct ML trend.
分析表明，共晶硅相的形状因子反映了AFS变质级别的变化趋势。 - On the basis of the Bean model and the Kim model, the dependence of the current concentration with the shape factor of the elliptical hole is discussed. Also, the singularity of current distribution around the crack is obtained.
分别基于临界态Bean模型和Kim模型讨论了临界电流集中性随椭圆孔洞形状因子的变化关系，并得到了线型裂纹尖端的临界电流奇异性。 - I got optimal shape factor corresponding to non-dimensional length on the base of different well network area and different thickness, and took into consideration the influence of anisotropic coefficients on the optimal shape factor.
得到了不同井网面积，不同厚度情况下无因次长度对应的最优形状因子，同时考虑了各向异性系数对最优井网形状因子的影响。 - The unit and the shape factor are defined to describe the feature of the forging part.
提出了单元和形状因子的概念，用来描述锻件特征，建立锻件特征信息模型。 - Morphologic parameters have been brought forward: area, girth, diameter, shape factor, fractal of edge.
采用颗粒形态学及分形理论，分析了大气颗粒相关形态参数：颗粒的投影面积，周长，等效圆直径，形态因子，边缘分形维数。